Loading... # 前言 有些人安装的linux的系统默认防火墙不是iptables,而是firewall,不知道该怎么使用,那就得使用以下方式关闭防火墙了。 # 关闭防火墙 ```apache systemctl stop firewalld.service #停止firewall systemctl disable firewalld.service #禁止firewall开机启动 ``` # 开启端口 ```apache firewall-cmd --zone=public --add-port=80/tcp --permanent ``` 命令含义 --zone #作用域 --add-port=80/tcp #添加端口,格式为:端口/通讯协议 --permanent #永久生效,没有此参数重启后失效 # 重启防火墙 ```apache firewall-cmd --reload ``` 其他常用命令: firewall-cmd --state ##查看防火墙状态,是否是running firewall-cmd --reload ##重新载入配置,比如添加规则之后,需要执行此命令 firewall-cmd --get-zones ##列出支持的zone firewall-cmd --get-services ##列出支持的服务,在列表中的服务是放行的 firewall-cmd --query-service ftp ##查看ftp服务是否支持,返回yes或者no firewall-cmd --add-service=ftp ##临时开放ftp服务 firewall-cmd --add-service=ftp --permanent ##永久开放ftp服务 firewall-cmd --remove-service=ftp --permanent ##永久移除ftp服务 firewall-cmd --add-port=80/tcp --permanent ##永久添加80端口 iptables -L -n ##查看规则,这个命令是和iptables的相同的 man firewall-cmd ##查看帮助 更多命令,使用 firewall-cmd --help 查看帮助文件 # 使用iptables来接管防火墙(可选) CentOS 7.x默认使用的是firewall作为防火墙,有的人不习惯firewall,要使用iptables必须重新设置一下 ## 1.直接关闭防火墙 ```apache systemctl stop firewalld.service #停止firewall systemctl disable firewalld.service #禁止firewall开机启动 ``` ## 2.设置 iptables service ```apache yum -y install iptables-services ``` 如果要修改防火墙配置,如增加防火墙端口3306 ```apache vi /etc/sysconfig/iptables ``` 增加规则 ```apache -A INPUT -m state --state NEW -m tcp -p tcp --dport 3306 -j ACCEPT ``` 保存退出后 ```apache systemctl restart iptables.service #重启防火墙使配置生效 systemctl enable iptables.service #设置防火墙开机启动 ``` 最后修改:2023 年 06 月 20 日 © 允许规范转载 打赏 赞赏作者 支付宝微信 赞 0 如果觉得我的文章对你有用,请随意赞赏